Earth Oil is hardwax oil which is used extensively in the wood flooring trade. Created in-house by the Mylands technical team, the Earth Oil collection is a blend of traditional and modern techniques of timber aging, and wood character enhancement. The concept originates from Myland’s vast knowledge of antique restoration, flooring finishes, decorative paints for Interiors, film, television and theatre.
The selection is highly influenced by high-end interior designers and architects. Earth Oil is based on natural oils and waxes, with natural look and feel. It is resistant to drinks, beverages and household liquids. Suitable for all solid wood floorings, block, strip and plank applications.
Preparation of Floor
New Timber:
- New timber should be sanded to ensure the surface is totally flat and free from contamination. Ensure the timber is at the correct moisture content and is left in the room to acclimatise before coating. Commence the mechanical sanding process and use sanding dust mixed with Mylands Joint Filler, 29 855 00005, to fill any cracks or holes. Finish sand using 80 grit paper on oak to keep the natural grain of the timber open to show the colour contrast of the Earth Oil. Vacuum the floor between each sanding operation and ensure the floor is thoroughly clean before application of an Earth Oil.
Previously Lacquered or Oiled Floors:
- Previously lacquered or oiled floors should be mechanically sanded through the grits to 80 grit. Ensure the surface is clean, dry and sanding-dust free before application of the Earth Oil.
Previously Earth Oiled Floors:
- To apply more Earth Oil to an already Earth Oiled floor, lightly abrade the surface using 180 – 240 grit paper and re-apply Earth Oil in a colour or natural.
Previously Earth Oiled Floors which have been overcoated with Earth Oil Overlay:
- Abrade the surface to remove the Overlay back to the original Earth Oil colour before recoating with the same coloured Earth Oil as originally used. If in doubt, sand back to bare timber and treat as a new floor
Application
Ensure all areas to be coated are well ventilated before and after use. Always test on a small area prior to application for colour approval. Apply with a brush removing excess with a rag within a few minutes.
Apply the Earth Oil Overlay 24 hours after your application of Earth Oil (recommended with Crushed Marble). Then allow an additional 24 hours before carefully replacing the furniture.
Maintenance
Vacuum clean or wipe with damp cloth or mop. Do not over-wet the floor. If after a period of time, the floor starts to show signs of wear, a further coat of Earth Oil can be applied
Coverage
Coverage will depend on type and porosity of the substrate and application, but should be an average of 8 – 12 m² per litre
Drying Time
Allow 4 – 6 hours at 20°C between coats. Allow a minimum of 24 hours after the final coat before replacing furniture or submitting the floor to heavy traffic. Drying time will be longer under conditions of low temperature or high humidity
Cleaning Equipment
White spirit. For Silver Grey please use water.
